Muzata 40set Stainless Steel Cable Railing Kits for 1/8" Wire Rope 40 runs Kit

Description

Muzata 40 sets Stainless Steel Cable Railing Kits for 1/8" Wire Rope
Includes:
T316 Marine Grade CK08 Series CA1 CD1 CS1
40-Pack Jaw Swage Stud Turnbuckle
40-Pack Fork Terminal Lag Screw Eye
80 - Pack
eye bolt screws
Recommended run length <10M
This stainless steel cable railing hardware fittings perfect for fixing 1/8 inch (3.2mm) stainless steel wire rope cable to timber and metal posts,great for outoor and indoor at any angle or flat stair's railing or horizontal,vertical,straight cable guardrail
for all cable railing fitting series CA1 ; for stair angled railing series CS1  ; for cable railing tool series CT1 ; for cable railing wire rope series WP1
180° free rotation
The angle of the terminal and end fitting can be freely adjusted up to 180 degrees,
perfect for any angle on horizontal railing and stair railing.
It can only work with wood posts, not for metal posts.
Large adjustable range
This turnbuckle has a large adjustable range, which leaves more tuning room to
deal with changes in cable length at different temperatures, also makes it easier to install for beginners.
Easy to install
This cable railing fitting is easy to install. You can DIY to install a cable railing system all by yourself without hiring pros.
T316 Marine grade stainless steel perfect for both indoor and outdoor projects.
1.Install fixed end side
Mark the position for the eye lag screw and drill a guide hole for it. Then screw in the lag screw with a wrench. Detach the ring, install the short terminal on the lag screw.
2.Crimp cable
Put cable into the terminal and swage it twice in the same position with different angles. Expand the tensioner to the longest state.
3.Install turnbuckle side
Measure the cable length and cut it with cable cutter. Remember to leave some room for future tightening. Then install the turnbuckle side with pretty much the same steps.
4.Tighten cable
Put cable into the turnbuckle and crimp. Tighten the cable by rotating the turnbuckle and fasten turnbuckle with the two nuts. Remember to leave some room for future temperature change.